The belt storage device can store several layers of belts

How should belts be stored?

If floor storage is required, the belts should be stored in a protective container and never exposed to foot traffic. Never twist, bend or crimp belts during storage and handling. Doing so will damage them. Do not hang belts from pegs as they will distort over time. Do not store belts under any state of tension.

Where should conveyor belts be stored?

In terms of the actual storage environment, the ideal place to store conveyor belts is in an indoor facility that is climate controlled, such as a warehouse or shop preferably under a covered shelter such as a warehouse. However, it is understood that a covered shelter is not always possible or available only on a limited basis.

How do you store a V-belt?

Do not hang belts from pegs as they will distort over time. Do not store belts under any state of tension. V-belts may be stored by hanging on a wall rack only if hung on a saddle with a diameter at least as large as the minimum diameter sheave recommended for the belt cross-section. If coiling a V-belt for storage, consult the supplier for limits.

What temperature should a belt be stored at?

Storage Temperatures: The belt should not be stored under extreme temperatures. If stored at temperatures below 32ºF (0ºC), it may be necessary to condition the belt for at least 24 hours prior to use at a temperature of no less than 50ºF (10ºC) in order to improve flexibility and reduce the risk of belt damage as per ISO 5285.

What is a conveyor belt guideline?

VEYOR BELTSYOUR GUIDELINESEMPERTRANSplaces the utmost importanc on the quality of its conveyor belts.For optimised belting performance and longer service durabil ow our recommendations inside.PurposeThis guideline describes the recommended procedure for creating optimal conditions for storage and

How to transport a conveyor belt?

3 Transportation of conveyor beltsIn order to avoid injuries and damages, following requiremen s must be met. 3.1 Lifting operationA recommended method for lifting rolls is to insert a steel core of suitable size with a square cros -section through the reel centre hole. Slings, steel cables or chains hanging from a crane/hoist with b