Filling the shearing machine nitrogen accumulator

How to fill a nitrogen bottle in a shearing machine?

Firstly, prepare nitrogen bottle and the nitrogen filling tool. The filling tool is normally shipped with the shearing machine. Step 2: connect the filling tool with the accumulator and the nitrogen bottle Step 3: open the valve on filling tool, then open the valve on the nitrogen bottle slowly

How to fill a nitrogen accumulator?

Here are the steps to fill the accumulator: Before you start the filling process, make sure that your nitrogen refill station is in good working condition. Check the pressure gauge and ensure that the nitrogen supply valve is open. If the nitrogen supply in your refill station is low, refill it to the recommended pressure level.

How to check the nitrogen pressure in a hydraulic accumulator?

Inspect the nitrogen pressure by accumulator nitrogen tool. If the nitrogen pressure is less than 5~6 Mpa, pls fill in. After inspection and the filling, pls follow up the oil filling procedures（5.7） CAUTION: ONLY FILL IN THE NITROGEN INSIDE THE ACCUMULATOR, OTHERS ARE STRICTLY PROHIBITTED 8.4 The maintenance of the hydraulic system...

How do you fill a nitrogen accumulator with a pressure gauge?

Attach the pressure gauge to a different source of nitrogen. Slowly open the valve to allow the pressure gauge to fill with nitrogen. Observe the pressure reading on the gauge and make sure it matches the desired pressure for your accumulator. If the pressure is too low, repeat the filling process until the desired pressure is obtained.

How to fill the oil accumulator?

To filling oil into the accumulator, it needs two persons to work together. Step 1: one person goes to back of the shearing machine. Find the valve with pressure gauge on the bottom of the accumulator. Open the valve. Step 2: one person goes to the front the machine. Find the oil filling button on the control panel.

How do I recheck my nitrogen accumulator pressure?

Here is how you can recheck the pressure: Start by turning off the nitrogen supply to avoid any accidental release. Disconnect the pressure gauge from the accumulator valve. Attach the pressure gauge to a different source of nitrogen. Slowly open the valve to allow the pressure gauge to fill with nitrogen.