Proteus energy storage inductor

How to model inductors in Proteus?

To model inductors in Proteus, place three inductors on the schematic and set their values. Then, double click the inductor L1 and enter the MUTUAL_ L2 = 0.707 and MUTUAL_ L3 = 0.924 to the Other Properties box to set the coupling factor between inductor L1 and inductors L2 and L3.

How to set up the circuit in Proteus?

Fasten your seatbelts as we're going to perform a circuit experiment in Proteus. Press the “P” button and select the first six components one after the other. Arrange the selected components according to the given diagram. Then, go to Terminal Mode>Ground and set the Ground Terminal with the Vsource.

How does a pure inductor work?

This energy is actually stored in the magnetic field generated by the current flowing through the inductor. In a pure inductor, the energy is stored without loss, and is returned to the rest of the circuit when the current through the inductor is ramped down, and its associated magnetic field collapses. Consider a simple solenoid.

How to remove a wire from a circuit in Proteus?

To remove a wire from a circuit in Proteus, right click on the wire you want to remove, then click 'Delete Wire'. Alternatively, you can double right click on the wire to remove it. In this example, right click on the wire connecting the voltage source to the resistor R1 to remove it.

How do I add a resistor in Proteus?

To add a resistor in Proteus, enter “res” in the Keywords box (Fig. 1.15) and press the Enter key. Proteus is not case sensitive, so you can also use “RES”. After pressing Enter, a resistor will be added to the DEVICES section (Fig. 1.16).

How to simulate a DC voltage source in Proteus?

To simulate a DC voltage source in Proteus, use the “vsource” block (Fig. 1.80). Figure 1.81 shows an example schematic with a vsource block. This block can simulate a constant DC voltage source.